I’ll be straight with it. I’m a smoker, I smoke inside, I have a PC that is also inside. I want to clean my PC thoroughly to buy it a few more years. I know about the q tip method, and the compressed air, and general methods of cleaning out gunk and junk from PC parts. But this boy is way too gunked up for a regular cleaning. So, I reckon, the easiest way to clean it is to dunk the dirtiest parts in a bath of isopropyl alcohol. I was considering acetone at first, but it’s way too strong of a solvent, and alcohol should be better at dissolving organic residues. Is this a good idea?
I hereby submit this query to the council, and await judgement.
No dunking, and make sure what you’re buying is mostly alcohol (> 95%) and not water/alcohol mixtures often used for disinfection. Using in combination with e.g., a toothbrush is probably your best bet. IPA (and acetone) can strip some adhesives and cause certain kinds of electrical insulation to swell or dissolve, so a targeted approach is better. IPA is flammable (though less so than acetone), so be careful/well ventilated when allowing parts to dry, and ensure parts are fully dried before reconnecting to power.
IPA itself is only about twice as toxic as ethanol and certainly less problematic by inhalation than tar in the long run. I wouldn’t bother with a mask mostly because it won’t do shit unless it’s a cartridge respirator. However, IPA can sometimes facilitate skin absorption. IDK specifically about tar buildup but recommend wearing gloves (disposable nitrile is fine).
I’m confused. Unless it’s just worded strangely and I misunderstood; IPA is isopropyl alcohol.