Obviously it wouldn’t. The Switch 2 is a different system, and you can count on it having different decryption keys, as well as new methods of checking the validity of older decryption keys.
Count on it taking at least another two years before this console gets hacked and running pirate roms.
Not ‘reportedly’, people confirmed it doesn’t work. it shows the games on your home screen but none of them launch. Also Nintendo can brick your system so don’t even try using it.
Yeah, I wonder if there’s a piece of hardware that facilitates the bricking that will be found soon, otherwise a large influx of ways to flash the Switch 2 with a safer firmware. The Switch 2 is pathetic by today’s standards anyway. Should’ve been a 2K OLED at the minimum
The switch 2 has good specs by today’s standards. Having anything higher than 1080p is a waste of time since there isn’t any handheld that can run higher than that. The steam deck is 800p…
But I want higher res than my eyes can resolve so I can brag about the specs even if it tanks the battery life
Yeah, I don’t need 1440p in handheld mode. It supports 4K in docked mode and that’s good enough for me.
I’m still skeptical of the overall performance but we’ll see. The Switch aged poorly and I’m afraid the Switch 2 will be similar. I don’t want to see first-party games throttling to 20fps in 5 years.
If it’s anything like the Wii, there’s no hardware to fully brick the console. Instead, it would likely just come up with a software error message on boot (usually after an update) and tell you to contact Nintendo Support, who presumably would completely reset your console and remove mods if you sent it in. Maybe ban the serial number from online too.
I’m not sure about the Switch 2, but with the Switch 1, hardware bricking was very possible. There’s a chip on the Switch 1 with a series of fuses, which intentionally burn out after after certain firmware updates. There’s a finite number of fuses (500+, I believe), based on the update schedule Nintendo had planned for the console, and the number of burnt fuses needs to match the firmware version you’re on, otherwise you can’t downgrade the firmware. If Nintendo wanted to, they could target a device to receive several “dummy” updates to burn the remaining fuses, effectively blocking any further firmware updates.
Theoretically, yes, they could do that with the electronic fuses to prevent firmware from booting, as the Tegra on Switch 2 likely retains the same system. However, they probably wouldn’t do it mostly because it would deprive them of boards for refurbished consoles, if not whole units they can go and turn into systems they can send back from the repair centre. Besides, all they really need to do with any potential brick is to stop most people from using the device and to give up. I can’t be entirely sure since I don’t know the internals that well, but it wouldn’t make sense for them to do an irrecoverable brick.
Thanks for letting me know about the eFuses though in the Switch 1 chip, wasn’t aware of those before.
Yet
