Blowing into an enclosed space is chaotic, the fan has to push against air currents being deflected. Blowing into an open space (aka sucking out of you dishwasher) is much more orderly, the fan can simply pull the air out and there are much fewer air currents running orthogonal.
This is as far as my very basic knowledge goes here. You can try this effect by exhaling and inhaling air through a barely open mouth or a straw.
EDIT: On a related note, never “blow” during fellatio.
Ah, I was wondering where all the Karens went.
At my job we recently had an old device that was used to produce the sound a phone makes when the line is busy, open, etc. . It’s about arm length and 20 cm thick, you can distinguish the cogs producing the phase from the signal.
I mean, yes of course I would, but solely because I somehow voted for Trump.
Thanks for the info! I didn’t think they were widespread, but figured they might be a bit wholesome and would light up this thread :)
Projecting ads onto the tunnel walls off of a moving subway. Seen in mainland Taiwan China.
I’d like to add that there are good versions of “microloans”! I learned that there used to be (or still are, didn’t check) non-profit " banks" in some parts of India (and South africa I think) that would give out small loans of a few dollars to a few hundred dollars (which can be quite a lot of money in India). There was no collateral and low interest, but a group of people had to apply for a loan together. Until the first loan was paid back, the rest of the group couldn’t apply again. It was meant to provide financial backing and capital to microbusinesses (e.g. fishers, farmers, peddlers) that would otherwise be excluded from the financial market due to a lack of collateral and otherwise be forced to take high-interest loans.
It’s an anti-missile system. To shoot down incoming missiles.
Great answers already, I’d like to add a few things: Lithium batteries like to be charged at 1C, meaning that if they have a capacity of 1.6 Ah they like to be charged at 1.6 A and will (theoretically) be fully charged in one hour (this is wrong in practice though). You can charge most of them at a higher rate (e.g. at 3.2 A), but they should be rated for it. If you don’t better, stick to a lower amperage. Too low of an amperage should not be an issue but I’m not sure - it will take ages though.
The voltage has to fit! Batteries change their voltage over the course of charging/discharging. This is more pronounced in older NiMH or NiCdH (discard those) batteries but still relevant. A 12V charger can charge your batteries to 12V. Most chargers can handle different voltages and will usually select the correct voltage depending on the battery. This is important if you are charging LiIons or LiPos (two types of Lithium batteries), as overcharging them is NOT advised. They generally peak at around 4.2V per cell I think with a working charge (don’t know the term) of 3.7V per cell. Some chargers require you to select the number of cells. Charging a 2-cell LiPo with 12-13 volt is a bad idea I wager and charging a 3-cell LiPo with 9.something volt won’t work (it won’t drain it, but the minimal voltage is higher than what the charger provides - current would like to flow the other way if It could).
TL,DR: If you can adjust the charging parameters manually or you are doing something the manual states you shouldn’t be doing, educate yourself. If however you only plug in your phone (with a painfully small battery at 2 Ah) and only provide a 1.5A*5V=7.5W charger, you are perfectly fine.
EDIT: It’s not thermocyclers.
I’m guessing it might be thermocyclers, I.e. PCR-machines.
You still need some consumables (esp. the proper primers), but the machine is entirely reusable. However, it is also a fairly basic and it sounds unlikely that Putler had a lack of thermocyclers.
True, every positive test is also a negative test and vice versa :D
I don’t mean to imply anything, but this post was listed maybe one scroll away from the piracy community welcoming everyone to SimpleX. Unfortunate timing.
That’s a fair assessment
I’ll probably have some tea, thanks :) Feel better now that I’ve slept
Considering all the provocation, I can’t say Israel might not be illegitimate. Did that offend you or scratch the wrong nerve? Maybe violence is never the right answer, but simpy the easier or even only one.
Sorry it had to be you, I’m probably looking for a fight right now. World’s been on my nerve.
No, that can’t be right, Black Flag released just a few years ago … I remember it like it’s yesterday …
Something to remember: thicker filaments, while they do last longer, worsen the ratio of light to heat.
Well, they had me there. Fair point.
I always wondered how people could talk or think about burning books and not consider themselves to be a villain. Wth, I probably wouldn’t even burn Mein Kampf or Mao’s red book and you want to burn novels you’ve enjoyed because the writer endorses a politician.
I once read a fairly interesting take on this: Historical settings are often chosen to wrap the story in a certain context in order to allow the reader to picture the style and theme without having to establish and explain a new setting first, so basically you skip on world building. If you read an analogy to Zeus you will immediately have an image in mind as well as a bunch of characteristics, no need to establish that beforehand.
Now, considering this it makes sense to choose a setting people already know - the 16th centruy Ottoman Empire is certainly interesting, but the average reader might know next to nothing about it and you have to explain everything first.
Why are these three settings used so much? Well, it’s positive feedback! Literature, Theatres and Video Games will select something well known and it receives popularity. In addition, a piece of media using a less-popular setting will have to a) compete with other media to become popular and b) provide plenty of worldbuilding in order to have the setting make sense. A piece of media that both establishes a “new” setting AND is very popular is going to be rare, making the entry of a new mythology/historical setting into mainstream difficult.