spoiler

For people that don’t know this is not how you use Calipers

  • HonoraryMancunian@lemmy.world
    link
    fedilink
    arrow-up
    14
    arrow-down
    33
    ·
    1 year ago

    This just tells me calipers should have 2 measuring bars on them, so gaps and other inside edges can be measured like this (maybe this already exists, idak)

    • flubba86@lemmy.world
      link
      fedilink
      arrow-up
      82
      ·
      1 year ago

      That’s what the two prongs at the top are for. Flip the caliper upside down, use the prongs to measure the inside dimension, and read it off the same scale.

        • rz2000@lemmy.world
          link
          fedilink
          English
          arrow-up
          23
          arrow-down
          2
          ·
          1 year ago

          “Caliper jaws for inside measurement—I thought of that. Turned out it already existed, but I arrived at it independently."

          • flubba86@lemmy.world
            link
            fedilink
            arrow-up
            12
            ·
            edit-2
            1 year ago

            I think the guy was actually referring to something a bit different, that is having a second number scale on the caliper that is offset by the width of the first jaw, so you can use the outside jaws for measuring inside dimensions. I don’t think that would work, however.

            • GewoehnlicherHamster@feddit.de
              link
              fedilink
              arrow-up
              13
              ·
              edit-2
              1 year ago

              The second scale sounds like a good Idea till you mess up everything due to using the wrong one. I once had a Spirit Level that was for plumbers and had a Second bubble-level built in that was even when the Level was tiltet to about 1.5 degree, great for waste-lines and gutters. Now everything in my House ist tilted by 1.5 degree except the plumbing and gutters.

            • HonoraryMancunian@lemmy.world
              link
              fedilink
              arrow-up
              6
              arrow-down
              2
              ·
              edit-2
              1 year ago

              I was indeed (and I think you’re right, the calipers would need at least to be parallel on their outer edges to work this way).

              I’m not sure what rz2000 was doing by (slightly wrongly) rewording basically what I wrote — I get the impression they think I was being full of myself for thinking of a (similar) concept that already exists (despite conceding that it already might) and felt the need to put me back in place.

            • brianorca@lemmy.world
              link
              fedilink
              arrow-up
              1
              ·
              1 year ago

              By using the same scale for inside and outside, you can take one measurement inside, and compare it to something else as outside without moving the scale at all.

    • Uranium_Green@slrpnk.net
      link
      fedilink
      arrow-up
      32
      arrow-down
      1
      ·
      1 year ago

      Can’t tell if I’m missing a joke here, but see those two small knife looking protruding from the opposite side (above) where they’re measuring, those are used for measuring internal diameter.

      The side they’re using is for outer diameter.

      And though you can’t see it in the pic, the thin bit of metal that extends out from the bottom can be used for measuring depth.