It was all pretty straight forward. The kit was made to be assembled with a bolt on neck all predrilled, so it was basically just shaping the body and headstock and then paint and varnish.
I did look up some painting techniques, but I really just wanted to stain the wood, so I did that with a brush and then 2 coats of varnish.
I had to sand the wood first to make it more open for staining instead of paint.
If you want to paint or spray paint you should probably keep or make a base coat to avoid the wood absorbing the paint.
It was a cheap telecaster-like kit, so I wasn’t too concerned with making mistakes, but I’ll admit that putting the saw into a guitar was a little daunting at first.
I used a multi-cutter for most of it to make very precise cuts. And lots and lots of sandpaper by hand with different grit sizes.
It only took a few evenings to do, so it is not difficult at all, but I guess it depends on how much you want to customize it.
Do you know the brand? Sounds like my next winter project.
I want to make one with normal pickups - Out1 and add a piezo bridge with a three way switch for an Out2. Some of the sounds people are getting by blending the two are incredible.
It was all pretty straight forward. The kit was made to be assembled with a bolt on neck all predrilled, so it was basically just shaping the body and headstock and then paint and varnish.
I did look up some painting techniques, but I really just wanted to stain the wood, so I did that with a brush and then 2 coats of varnish. I had to sand the wood first to make it more open for staining instead of paint. If you want to paint or spray paint you should probably keep or make a base coat to avoid the wood absorbing the paint.
It was a cheap telecaster-like kit, so I wasn’t too concerned with making mistakes, but I’ll admit that putting the saw into a guitar was a little daunting at first.
I used a multi-cutter for most of it to make very precise cuts. And lots and lots of sandpaper by hand with different grit sizes.
It only took a few evenings to do, so it is not difficult at all, but I guess it depends on how much you want to customize it.
Do you know the brand? Sounds like my next winter project.
I want to make one with normal pickups - Out1 and add a piezo bridge with a three way switch for an Out2. Some of the sounds people are getting by blending the two are incredible.
The kit I used was a Harley Benton from Thomann.
Awesome. Thank you.
No problem. Have fun.
I don’t know if there’s a community for this, but anyway, this is my “surf guitar”.:
It’s been a few years but it still looks like the day I made it.
That looks amazing. Thank you for sharing.